Wood Stone AMP Series 64: every indicator light on the deck is flashing
The AMP Series 64 electric deck oven can be set to 850 °F.
Mon–Sat, 8am–8pm
- Temperature and sensors
- Pizza oven thermostat and control repair
- Source: Wood Stone
Book a visit
Three short steps, about a minute.
or call (844) 747-3662
Loading appointment form…
The appointment form couldn’t load. Please try again.
What All indicator lights flashing
actually means.
The AMP Series 64 electric deck oven can be set to 850 °F. If the chamber goes past its maximum, a safety thermostat stops the deck and all the lower indicator lights flash as the alarm.
Wood Stone pizza oven display · also shown as indicator lights flash
What to do when All indicator lights flashing shows on the pizza ovenKind of codeTemperature and sensors
A probe is handing the controller a reading it cannot believe, or none at all: a deck or tunnel sensor coated in baked-on flour and grease, its lead chafed or scorched where it passes the heat, or a connector loosened by years of doors slamming. The oven then runs hot, stalls short of its setting or shuts the heat off to protect itself. Letting the oven cool and restarting it is reasonable; a sensor that still reads wrong sits behind a panel, and that is a visit.
Usually leads toPizza oven thermostat and control repair
Thermostats calibrated or replaced, probes, timers, boards and displays repaired, so the pizza oven holds the temperature the cooks set and shows the right number.
Shows up asPizza Oven Error Code on a Deck, Conveyor or Rapid-Cook Display
A pizza oven error code shows as letters or numbers on the display of a conveyor, deck or rapid-cook oven, a flashing light on its panel, or a message about ignition, heat, belt or airflow.
MakeWood Stone
Where a Wood Stone oven faces the dining room, the tech plans the visit around guests who can watch the hearth from their tables.
SourceWood Stone AMP Series 64 electric deck oven installation and operation manual (M0367)
Wood Stone AMP Series 64 high-temperature electric deck ovens (WS-HD-37, WS-HD-45 and WS-HD-61).
Before you book,
in this order.
Each step comes from Wood Stone's own guidance for All indicator lights flashing on its pizza ovens. Follow it to the end: the last card says whether this is a visit.
Leave the deck off and let it cool fully.
Following the Wood Stone manual, unscrew the cap over the safety thermostat reset, press the button, and put the cap back; the lights should stop flashing.
If it trips again, stop using that deck and book a visit so the controller and elements can be tested.
Still there?
It usually turns into pizza oven thermostat and control repair. Book with the code and the model number.
What not to do
Flashing lights on this deck are not a timer finishing or the economy mode. They are also not a power cut, which leaves the panel dark.
What you may
notice with it.
The pizza oven problems All indicator lights flashing tends to arrive with. Answer these at the pizza oven before anyone is booked.
All problems
Where All indicator lights flashing usually leads
Pizza oven thermostat and control repair.
Wood Stone
pizza ovens.
Where a Wood Stone oven faces the dining room, the tech plans the visit around guests who can watch the hearth from their tables.
Wood Stone pizza oven repairMore Wood Stone codes
Temperature and sensors on other makes
All 11 codes of this kind
Outdoor gas pizza oven
A stainless pizza oven on a counter, a cart or set into masonry, fired by propane or natural gas under a stone floor and a low insulated dome.
Wood-fired pizza oven
A refractory dome over a firebrick or cast hearth, fired with wood and often a gas burner too, with a chimney, a door and thick insulation around it.
Commercial deck oven
A pizzeria's stacked steel oven with stone decks, heated by gas burners or electric elements, each deck with its own door, thermostat and controls.
In Wood Stone's own words
All the indicator lights on the lower control panel will start to flash, signaling an alarm. Wait until the oven cools down.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Wood Stone AMP Series 64 high-temperature electric deck ovens (WS-HD-37, WS-HD-45 and WS-HD-61).
Wood Stone All indicator lights flashing pizza oven repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about All indicator lights flashing.
Can I clear All indicator lights flashing myself?
Why are all the lights flashing on my Wood Stone AMP deck?
Where is the reset on a Wood Stone AMP Series 64 deck?
Is it safe to keep resetting the AMP deck's safety thermostat?
Back to your everyday
Still showing All indicator lights flashing?
A booking with a code goes further when it has the code copied as shown, the model and serial from the rating plate, and a note on whether the oven still lights, heats or moves its belt. With those three, the office can match the likely part to your oven the same day.