Fontana Forni noP: no meat probe is plugged into the Volta pizza oven
The Volta has two meat-probe ports with their own temperature readouts.
Mon–Sat, 8am–8pm
- Mode, not a failure
- No repair needed
- Source: Fontana Forni
Book a visit
Three short steps, about a minute.
or call (844) 747-3662
Loading appointment form…
The appointment form couldn’t load. Please try again.
What noP
actually means.
The Volta has two meat-probe ports with their own temperature readouts. When a port is empty, its readout shows noP instead of a temperature. It does not affect the burner or the oven temperature.
Fontana Forni pizza oven display · also shown as NOP
What to do when noP shows on the pizza ovenKind of codeMode, not a failure
No part of the oven has failed; the display is reporting a state someone chose or the oven entered on its own. A cool-down keeps the blowers turning after the heat is off until the cavity or the tunnel has dropped to a safe level, an energy save setting lets the decks sag between rushes, and a menu lock stops anyone on the line from changing the bake times. No part is needed: letting the cool-down run out, or the key sequence in the manual, brings the oven back.
Usually leads toNo repair
If you are not using a meat probe, ignore noP; the oven heats normally.
Shows up asPizza Oven Error Code on a Deck, Conveyor or Rapid-Cook Display
A pizza oven error code shows as letters or numbers on the display of a conveyor, deck or rapid-cook oven, a flashing light on its panel, or a message about ignition, heat, belt or airflow.
MakeFontana Forni
A Fontana Forni visit leaves time for the door and the dial thermometer, two small parts that decide whether an owner trusts the fire at all.
SourceFontana Forni Volta 70 and 90 manual, USA and Canada edition, control panel
Volta 70 and Volta 90 smart gas ovens, which ship with two food probes.
Before you book,
in this order.
Each step comes from Fontana Forni's own guidance for noP on its pizza ovens. Follow it to the end: the last card says whether this is a visit.
If you are not using a meat probe, ignore noP; the oven heats normally.
If a probe is plugged in and the readout still shows noP, push the plug fully into its port.
Try the probe in the other port; if noP follows the probe, the probe or its cable is damaged and needs replacing.
Cleared?
The code has left the display, the decks or the tunnel come up to the set heat and hold it through a full service, the belt keeps its speed and the blowers run steady, all with no part changed. If the same code returns within a week, or on the next busy night, say so when you book.
What not to do
noP has nothing to do with the chamber probe that controls the burner; losing that one shows Er1. It is not a stop condition either, and the oven keeps heating with noP on the screen.
What you may
notice with it.
The pizza oven problem noP tends to arrive with. Answer these at the pizza oven before anyone is booked.
All problems
No repair indicated
Nothing to repair.
No part of the oven has failed; the display is reporting a state someone chose or the oven entered on its own. A cool-down keeps the blowers turning after the heat is off until the cavity or the tunnel has dropped to a safe level, an energy save setting lets the decks sag between rushes, and a menu lock stops anyone on the line from changing the bake times. No part is needed: letting the cool-down run out, or the key sequence in the manual, brings the oven back.
Fontana Forni
pizza ovens.
A Fontana Forni visit leaves time for the door and the dial thermometer, two small parts that decide whether an owner trusts the fire at all.
Fontana Forni pizza oven repairMore Fontana Forni codes
Mode, not a failure on other makes
Outdoor gas pizza oven
A stainless pizza oven on a counter, a cart or set into masonry, fired by propane or natural gas under a stone floor and a low insulated dome.
Wood-fired pizza oven
A refractory dome over a firebrick or cast hearth, fired with wood and often a gas burner too, with a chimney, a door and thick insulation around it.
In Fontana Forni's own words
If the meat probes are not connected to the port, “noP” appears on the display.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Volta 70 and Volta 90 smart gas ovens, which ship with two food probes.
Fontana Forni noP pizza oven repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about noP.
Can I clear noP myself?
Should I worry about noP on my Fontana Volta display?
My Volta meat probe is plugged in but shows noP. What now?
Does noP on a Fontana Volta stop the timer or alerts?
Back to your everyday
Still showing noP?
A booking with a code goes further when it has the code copied as shown, the model and serial from the rating plate, and a note on whether the oven still lights, heats or moves its belt. With those three, the office can match the likely part to your oven the same day.